Conference | 2/9/2005 | 2/9/2005 | 2/9/2005 | P | PASS |
Jim Schmer
|
|
|
per your request check out clearance in front of control cabinet. ok - JMS 2/9/2005 10:10:23 AM
|
Final | 2/3/2005 | 2/8/2005 | 2/8/2005 | P | PASS |
Bob Reichert
|
|
|
We installed a new 60 amp 480 volt 3 phase circuit #25-27-29 from Panel H1, to a new fused disconnect on the north wall. Wired to a transformer from this disconnect, and from this transformer to a receptacle for their new machine.This is in the northwest building.THANKS!!!!Dan.; Phone #: ###-#### Internet Inspection Request from: Dan Mitchell ok to final 2/9/2005 10:09:49 AM
|
Electrical Rough-In | 1/24/2005 | 1/25/2005 | 1/25/2005 | P | PASS |
Bob Reichert
|
|
|
We 1)installed a new 20 amp 230 volt 3 phase circuit(#2,4,6) from Panel "L3" to a new twist-lok receptacle for the "EZ-Trimmer" machine. 2)installed a new 15 amp 230 volt 3 phase circuit (#1,3,5) from Panel "L3" to a new disconnect for a new Air Dryer and connected the Air Dryer to this disconnect.3)installed a new 60 amp 480 volt 3 phase circuit (#32,34,36) from Panel "H1" to a new disconnect for the new Air Compressor and connected the compressor to this new disconnect.4)installed a new 20 amp 120 volt circuit from Panel "L2" to a new switch on the outdoor canopy post to control 3 new receptacles for 3 truss roller motors under the outdoor canopy at the S.E. corner of the N.W. bldg. All of this work is at the N.W. bldg.The non-UL approved machine has been disconnected and is being shipped out of state, to be replaced with a new UL-Approved unit in the near future.Thanks!!!Dan.; Phone #: ###-#### Internet Inspection Request from: Dan Mitchell called contr about label for pane H1. ric ok 1/25/2005 12:14:20 PM
|
Electrical Rough-In | 1/3/2005 | 1/4/2005 | 1/4/2005 | A | PART |
Bob Reichert
|
|
|
Would like to meet you at 8:30 AM to inspect 1 new circuit to 1 new machine, and 1 existing circuit to 1 new machine.This is in the north-west building.Thanks!!!!Dan.; Phone #: ###-#### Internet Inspection Request from: Dan Mitchell called contr. and said they should not hook up machine since it is not a listed assembly. 1/4/2005 9:49:09 AM
|