Information based on query as of Sunday, June 30, 2024.
Permit Information
Permit NumberELE05-01278
StatusFinaled
Name MITCHELL ELECTRIC
Site Address 2910 E AMITY RD
Project Name 
Customer Number 
ePlanReview 
Description
Run 6 new circuits per initial cert of value $4,500///4/15/05 BAS
Contact Information
See Activities list for contact information
Show All Activities
DescriptionReceivedRequestedCompletedAM/PMDispositionAssigned To 
Final4/27/20054/27/20054/27/2005PPASS
DetailsMike Kinnear
We replaced the #12awg wires with #10awg wires in that 1" conduit you were concerned with.Thanks!!!Dan.; Phone #: ###-#### Internet Inspection Request from: Dan Mitchell ok final
Final4/22/20054/26/20054/26/2005ANR
DetailsMike Kinnear
Will meet you at 8:30 AM at the panel to go over the job.Thanks!!! Dan.; Phone #: ###-#### Internet Inspection Request from: Dan Mitchell boise city code no code violation will be retained -- derating pipe fill
Final4/22/20054/22/20054/22/2005PPART
DetailsMike Kinnear
We: 1) ran 2 new 20 amp 120 volt circuits to 2 new duplex receptacles on a pillar. 2)Ran 2 new 3 phase circuits to 2 new non-fused disconnects with new twist-lok receptacles beneath the disconnects. 3)ran a new 20 amp 120 volt circuit & a 220 volt welder
Rough-In Permanent Service4/15/20054/15/20054/15/2005PNR
DetailsMike Kinnear
We replaced the old small Panel "MS" with a new larger one in the exact same location.We then installed 2 new 3phase circuits(#22-24-26, & #21-23-25) from this Panel "MS" to 2 new non-fused disconnects with 2 new twist-lok receptacles below them. This is