| Electrical Rough-In | 8/4/2009 | 8/4/2009 | 8/4/2009 | P | FAIL |
 Bob Reichert
|
|
|
michael Phone #: ###-#### told owner he will have to get licensed electrical contractor to do further work, needs nail plates, 1 1/4" for wire, free length conductor, flush boxes with plywood wall covering, 20a circuits with wire size for laundry and bath, receptacle spacing, make-up, told owner that his permit will have to be voided
|
| Electrical Rough-In | 7/21/2009 | 7/22/2009 | 7/22/2009 | A | CANC |
Bob Reichert
|
|
|
###-#### wrong type request, see conference
|
| Conference | 7/22/2009 | 7/22/2009 | 7/22/2009 | A | DONE |
Bob Reichert
|
|
|
###-#### talked about make-up, 1 1/4", spacing receptacles, small appliance branch circuits, abandoned wiring, service clean-up, no esc this project
|
| Permanent Service | 12/8/2008 | 12/8/2008 | 12/8/2008 | P | CANC |
Bob Reichert
|
|
|
power co called about changes to passed p/s, went to inspect and owner made changes and created violations, told him he was supposed tp remove receptacle, close openings, not run nm cable in raceway, close lb fittings, close panel, strap conduit,etc. Told owner that he needs temp pole or to finish wiring before power can be reconnected.
|
| Permanent Service | 12/3/2008 | 12/4/2008 | 12/4/2008 | P | PASS |
Bob Reichert
|
|
|
mike Phone #: ###-#### p/s o/h rec ok
|
| Electrical Rough-In | 11/19/2008 | 11/20/2008 | 11/20/2008 | A | FAIL |
Jack Frank
|
|
|
mike Phone #: ###-#### met owner explained what is required for p/s , and r/i for 5 rms, and what circuits are required for kit ,laundry , din, liv. bed rm note owner needs to update permit for 5 rms and a p/s
|
| Conference | 10/30/2008 | 10/31/2008 | 10/31/2008 | A | DONE |
Bob Reichert
|
|
|
mike- call 1st before insp Phone #: ###-#### met owner talked about service upgrade , rewire of burned house, told owner that if he has electrician hepl him, that he would have to get permit, talked about grounding, mast, service drip loop too low
|