Final | 2/27/2020 | 2/28/2020 | 2/28/2020 | A | PASS |
Ben Livingston
|
|
|
Protection for the AC''s have been added. Inspection requested via web by Aaron Alandt
|
Final | 2/24/2020 | 2/25/2020 | 2/25/2020 | A | FAIL |
Ben Livingston
|
|
|
Phone #: ###-#### Inspection requested via web by Aaron Alandt - condencers in alley need tobe protected from damadge -
|
Final | 1/29/2020 | 1/30/2020 | 1/30/2020 | A | FAIL |
Troy James
|
|
|
HOPING TO GET A PARTIAL FINAL SO THEY CAN MOVE IN, A/C''S ARE STILL A COUPLE WEEKS OUT - PROJECT MANAGER IS KEVIN ###-#### Phone #: ###-#### Inspection requested via web by Aaron Alandt Need to have the a/c units set for final.
|
Mec-Request for Extension | 1/14/2020 | 1/14/2020 | 1/14/2020 | P | PASS |
Ben Livingston
|
|
|
This job is not ready yet, we still have to set the a/c''s - not sure when this builder will be ready Phone #: ###-#### Inspection requested via web by Aaron Alandt
|
Mec-Aging Inspection | 1/14/2020 | 1/14/2020 | 1/14/2020 | | CANC |
Ben Livingston
|
|
|
wip
|
Pressure Test | 8/7/2019 | 8/8/2019 | 8/8/2019 | A | PASS |
Ben Livingston
|
|
|
Inspection requested via web by Aaron Alandt --20lb-- -- 5lb x2--
|
Rough-in | 8/7/2019 | 8/8/2019 | 8/8/2019 | A | PASS |
Ben Livingston
|
|
|
Inspection requested via web by Aaron Alandt
|
Rough-in | 8/6/2019 | 8/7/2019 | 8/7/2019 | A | FAIL |
Ben Livingston
|
|
|
Phone #: ###-#### Inspection requested via web by Aaron Alandt - dryer vent crimps are going against air flow-
|
Pressure Test | 8/6/2019 | 8/7/2019 | 8/7/2019 | A | FAIL |
Ben Livingston
|
|
|
Phone #: ###-#### Inspection requested via web by Aaron Alandt -- at fireplace need gto protect gas flex 6" either direction from studs-
|
Rough-in | 8/5/2019 | 8/6/2019 | 8/6/2019 | A | FAIL |
Ben Livingston
|
|
|
Phone #: ###-#### Inspection requested via web by Aaron Alandt -- mainlvl dryer vent has screws in it-- -- need to insulated return on main lvl exterior wall--
|
Pressure Test | 8/5/2019 | 8/6/2019 | 8/6/2019 | A | FAIL |
Ben Livingston
|
|
|
Phone #: ###-#### Inspection requested via web by Aaron Alandt -- 20lb okay-- --5lb flue x2 okay-- -- need approved stricker plates at fireplace where gas flex runs through studs, need to protect gas flex at furnace #2 left stickers at both locations--
|