(BOISE AIRPORT - CBRA ROOM - LOCATED ABOVE THE BAGGAGE MAKE-UP AREA) (7-18-16 PLAN MODIFICATION TO REMOVE AN EXISTING DOOR AND FRAME AND TO REPAIR THE WALL FINISH ASSOCIATED WITH THAT WORK.) (1-20-16 THE WORK UNDER THIS PERMIT WILL BE DONE PER THE PHASING SCHEDULE ON SHEET G0.3. A TOTAL OF 3 PHASES ARE DEFINED.) The fire sprinkler system is used for occupancy. To expand and remodel the existing CBRA Room located on the mezzanine above the baggage make-up area. The room will be expanded by about 1,147 square feet from about 1,090 square feet to about 2,237 square feet. The changes are needed to accommodate the new baggage conveyor system layout. Work is to include interior nonbearing walls, interior doors, new handrails to serve an existing stairways, anti-fatigue flooring, suspended acoustical ceiling, gypsum board soffits, spray applied fire proofing to create a 2-hr fire-resistance-rated floor assembly and 2-hr supporting elements, and finishes. An existing steel grate in the mezzanine floor will be removed and the floor opening will be infilled with a metal deck and concrete floor. A notch in the bottom of an existing beam will be enlarged to provide the required headroom at a walking surface. Steel box headers will be installed at alcoves and wall openings to support the walls above. Special Inspection is required for welding and the application of spray applied fire proofing. An existing roof top HVAC unit will be removed and a new unit, using a transition curb adapter, will be installed on the existing curb. The new HVAC unit is not allowed to weigh more than the removed HVAC unit. The work is required to comply with the approved drawings, with the plan review report, with the structural calculations, and with all applicable codes and ordinances. The fire sprinkler system is required to comply with NFPA 13 and the fire alarm system is required to comply with NFPA 72 as regulated by the Fire Department. **CJW**