I called Mark Watson, again, ###-####. He indicated he had replaced the existing fire alarm mother board with a Vista 20P alarm board. He thought that was just "maintenance" work but after Troy's inspection and phone call, he had gone back and removed the new board and re-installed the original board. He said he hadn't tested afterwards, as the owner was turning the job over to Mountain Alarm. He said he was a licensed contractor; I asked if he had an electrical license, he said he has a low voltage license but didn't have his license number with him; he said he uses another person who is a master electrician for high voltage work.

dan Phone #: 724-632. ok for perm occ.

All life safey items have been corrected except for the fire alarm panel. The tenant hired "The Fire Alarm Guy" to get the system running again. I contacted him to verify different items and found that the circuit board of the panel had been replaced with another. Also there is only one phone line active. Per the monitoring company the tamper zone is rolling the fire trucks. I informed Mark that permits are required for this type of work and that he should contact sam rogers for further information. I contacted sam as well.

Provide emergency lighting in the warehouse, remove the thumbturn lock from the main exit, provide indicator at the main exit lock, install all ceiling tile, provide covers on the electrical outlets, provide verification that the fire alarm system is functional, provide approved hardware on the warehouse exit doors and the north facing showroom door.

Occuapancy permit / Field verify