This quick permit scope of work is to provide a new chime/strobe, relocate an existing smoke detector, remove an existing smoke detector, and to relocate an existing in-duct detector. The new device shall be added to an existing circuit.53. Approval is subject to field measurement of the EOL voltage drop. The voltage drop calculations are based on a 10% drop, therefore the minimum acceptable voltage is 21.6V with the AC power off. Any measurement below this voltage will be considered insufficient to run the NACs at the end of useful battery life of 20.4V. UL 864, Standard for Control Units for Fire Signaling Systems. The installing contractor shall have available at final inspection a voltage meter and measure end of line voltages; witnessed by the field inspector. There are no written review comments. Associated building permit: BLD11-01767 (SARMC – South Tower – Radiology Dept.) Permit is to remodel an existing 750 square foot imaging room by installing new equipment and new finishes. This building is fully fire sprinklered. Approval contingent upon adhering to the approved plans on file and structural engineering attached to plans. Work to include: installation of new structural frame to support imaging equipment (suspended from ceiling), installation of new floor trench for mechanical and electrical, relocate screen walls, relocate existing sink, and finishes in compliance with chapter 8 of the 2009 IBC. This building is fully Fire Sprinklered with an approved Fire Alarm system. Any alterations or modifications to the buildings Fire Sprinkler or Fire Alarm system WILL REQUIRE A SEPARATE PERMIT and shall be installed per NFPA 13 & NFPA 72 as regulated by the Boise Fire Department. **TLW**