| First Notice | 11/14/2019 | 11/14/2019 | 11/14/2019 | | DONE |
 Jack Reynolds
|
|
|
This permit finaled on the web by jeremy wanders
|
| Final | 11/13/2019 | 11/14/2019 | 11/14/2019 | A | PASS |
Jack Reynolds
|
|
|
Trimmed roofing material away from metal roof flashing to have a 1" clearance around b vent to combustibles. Phone #: ###-#### Inspection requested via web by jeremy wanders
- final ok
|
| Final | 11/12/2019 | 11/13/2019 | 11/13/2019 | A | FAIL |
Jack Reynolds
|
|
|
Installation instructions are inside a document holder on the side of the unit heater. There is no attic area to inspect the flue. There is only about a 18" thick space between the roof and the ceiling. Phone #: ###-#### Inspection requested via web by jeremy wanders
- b vent going through roof membrane needs 1" clearances
|
| Final | 10/28/2019 | 10/29/2019 | 10/29/2019 | A | FAIL |
Jack Reynolds
|
|
|
Unit heater is located at the entrance to the wash tunnel. Where the cars enter the wash tunnel on the left hand side. Replaced existing unit heater with a new unit heater with all the same specs and dimensions. Old flue was corroded pretty bad and disconnected inside the attic. Complete new flue ran. Phone #: ###-#### Inspection requested via web by jeremy wanders
- need installation instructions onsite and need to check clearances of new flue through attic
|
| Issue PAID IN FULL permit | | | 10/28/2019 | | DONE |
|
|
|
Payment received via Govolutions
|
| Application received | | | 10/28/2019 | | DONE |
|
|
|
This permit was created on the web by jeremy wanders
|