*MNS TEST CENTER* (HP #2) To perform a two phase remodel of a 15,626 sq. ft. area within the existing 76,000 s.f. HP Building #2, Lower, for use as a test center for new products and configurations, that could include servers & disc arrays. Phase I (5,844s.f.) to include construction of new interior non-bearing, non-combustible walls at the North & West end of new Test Area"s "1-A" & "Test Launch"; relocate & install existing demountable wall to the South side of Test Area "1-A"; install raised floor system & access ramps thereto & all applicable components to Test Area "1-A" & Test Launch to finish Phase 1, to include structural modifications for support of and placement of 4 mechanical 'Dry Cooler' units on the existing roof structure. Phase II (9,782s.f.) includes installation of raised floor within the Test Area's "1-B", "2" & "3"; removal of demountable partition between Test Areas "1-A & 1-B"; adjustment of ramp access to raised floor areas; modification of doors to power operated break away units, interstitial framing for electrical cable support system above raised floor areas through-out, new suspended ceiling grid system through-out test areas; new pumps & support system on mechanical mezzanine of Link between Bldgs. 2 & 3; additional 10 roof top 'Dry Coolers' & support structure on roof; and all electrical, plumbing, mechanical, fire & alarm system equipment and upgrades for the new "MNS Test Center" to function and remain code compliant. To remodel an existing 1,188 s.f. storage room. All per approved plans, notes on plans and attached plan review comments as part of approved plans. A "Letter of Completion / Compliance" is required for the final approval showing code compliance for use and occupancy. The rated 1-hour corridors located at the East & West ends of the new Test Areas shall be maintained. NOTE: This building is fully sprinkled for allowable area increase. PC#01-159/drs