Information based on query as of Thursday, June 20, 2024.
Permit Information
Permit NumberBLD16-02382
StatusFinaled
Name HARDING HOMES INC
Site Address 3245 W TARGEE ST
Project NameBryn Mawr Cove Cottages
Customer NumberBLD16-02352 EPLAN, 16-02381 -02385
ePlanReview 
Description
(6 PERMITS TOTAL FILED UNDER BLD16-02352 IN EPLANREVIEW)Permit for the construction of a new 1485 sq. ft., two story (first story 1003 sq. ft., second story 482 sq. ft.) single family dwelling with 3 bedrooms, 2.5 bathrooms, and an approximately 108 sq. ft. of covered patio/porch per the approved plans, and any notations. R-2D zoning and setbacks per planning. **DAF**
Contact Information
See Activities list for contact information
Show All Activities
DescriptionReceivedRequestedCompletedAM/PMDispositionAssigned To 
BLD-Final11/15/201611/16/201611/16/2016APASS
DetailsJim Storey
DOC - Permit Finaled11/16/201611/16/201611/16/2016PPASS
DetailsJim Storey
BLD-Final11/15/201611/15/201611/15/2016PDEFR
DetailsJim Storey
Bill Phone #: ###-####
BLD-Energy code compliance9/30/20169/30/20169/30/2016PPASS
DetailsPhil Shearer
Bill Phone #: ###-####
BLD-Framing/Rough-in9/28/20169/28/20169/28/2016PPASS
DetailsJim Storey
would like call ahead; bill Phone #: ###-####
BLD-Framing/Rough-in9/22/20169/22/20169/22/2016PFAIL
DetailsJim Storey
Phil Phone #: ###-####CUTTING, NOTCHING AND DRILLING

R502.8.1 Sawn lumber.
Notches in solid lumber joists, rafters and beams shall not exceed one-sixth of the depth of the member, shall not be longer than one-third of the depth of the member and shall not be located in the middle one-third of the span. Notches at the ends of the member shall not exceed one-fourth the depth of the member. The tension side of members 4 inches (102 mm) or greater in nominal thickness shall not be notched except at the ends of the members. The diameter of holes bored or cut into members shall not exceed one-third the depth of the member. Holes shall not be closer than 2 inches (51 mm) to the top or bottom of the member, or to any other hole located in the member. Where the member is also notched, the hole shall not be closer than 2 inches (51 mm) to the notch.
truss engineering
BLD-Framing/Rough-in9/21/20169/21/20169/22/2016PNR
DetailsJim Storey
Phil Phone #: ###-####
BLD-Framing/Rough-in9/20/20169/20/20169/20/2016PNR
DetailsJim Storey
Bill Phone #: ###-####
BLD-Wall Bracing9/1/20169/2/20169/2/2016PPASS
DetailsJim Storey
Bill Phone #: ###-####
BLD-Foundation7/29/20167/29/20167/29/2016PPASS
DetailsPhil Shearer
Phone #: 2086971241 >> Inspection requested via mobile web by Heron
BLD-Footing7/27/20167/28/20167/28/2016PPASS
DetailsJim Storey
Phone #: 2086971241 >> Inspection requested via mobile web by Heron