overheadWork Scope: Over Head Only
Add and relocate heads to accommodate a new wall and ceiling layout on the 1st floor of this single story office bldg... With in an existing warehouse area, heads were relocated out to 130-ft/2 per head. Calculations to support the modification have been provided. Three additional heads were relocated in the shell area to meet spacing requirements at the new demising wall. Mechanical tees will be added were necessary to supply a new head location. The fire sprinkler system work shall comply with the IFC 2003, the attached review comments/conditions, as regulated by the Fire Chief. The review comments/conditions, permit and fire "Inspection Card" are required to be on site as a condition of this work, to provide witness of compliance verification of minimum code. This permit is attached to BLD07-02060. When tenant work affects fire sprinkler protection outside the permitted work area due to the installation of tenant-demising or new partition walls, the affected area sprinkler coverage outside the BLD permit will fall under the Fire Permit scope of work, to maintain the required fire protection within the fire sprinklered facility. The “Riser” and its supplies which include all appurtenances (including tamper, alarm and alarm monitoring) relating to the normal and correct function and integrity of this system will fall under the jurisdiction for code compliant verification.Revised Work Scope: Plan Modification / Over Head Only
The wall separation between the office space and the warehouse area was not full height. The contractor had to add 15’ perimeter protection. A total of 15 heads were affected by this plan modification. This work has been noted on the plans as Wall Rev. dated 01/16/08